Foxconn NF4SLI7AA-8EKRS2

**MIG-31** · Oct 31, 2005, 12:47 PM

The board is laid out pretty well, my only gripe with the layout is the 4 pin ATX 12V header, I would still like to see this on an outside edge, it just makes wire management so much easier. There is also a 4 pin plug for a standard Molex right above the 1st PCI-E 1x connection, this also would have been nice to see either on the top edge or the right edge along with the rest of the connections. This Molex connection also forces the expansion slots down lower on the board. You might want to take this into consideration, especially if running in SLI. I would have had to relocate my pump if I was running dual video cards, as it is with a single card there is barely room for the pump.
_______________
Review: Viperlair

Oct 31, 2005, 12:47 PM	#1
MIG-31 DH News MOD Join Date: Dec 2002 Location: Nottingham,UK Posts: 42,583 Rep Power: 186 System Specs	Foxconn NF4SLI7AA-8EKRS2 The board is laid out pretty well, my only gripe with the layout is the 4 pin ATX 12V header, I would still like to see this on an outside edge, it just makes wire management so much easier. There is also a 4 pin plug for a standard Molex right above the 1st PCI-E 1x connection, this also would have been nice to see either on the top edge or the right edge along with the rest of the connections. This Molex connection also forces the expansion slots down lower on the board. You might want to take this into consideration, especially if running in SLI. I would have had to relocate my pump if I was running dual video cards, as it is with a single card there is barely room for the pump. _______________ Review: Viperlair __________________ Please Post Your News Submissions Here How you can help DriverHeaven by using Digg!