|
|||||||
![]() |
|
|
LinkBack | Thread Tools |
|
|
#1 |
|
DriverHeaven Senior Member
|
Are these dangerous temperatures?
Hello guys
I just opened AI Suite and immediately got a temperature warning for my motherboard. It was over the threshold (45*C) and sitting at 50*C...I have a screenshot attached with the different temp sensors I know that my sensors are fine because i aimed a 40cm fan at the side of the case and the temperature went down to 29*C. I odn't understand this, because the temperatures used to be at about 38*C ![]()
|
|
|
|
|
|
#2 |
|
DriverHeaven Extreme Member
|
Re: Are these dangerous temperatures?
Hi Issak on the temps the ASUS board I have here always runs a bit hotter than the Gigabyte around 42C. I don't see anything particularly dangerous although odd the temps used to be around 38C.
Have you changed anything like the position of fans or video card? (AUXTIN in most cases is a sensor that isn't available on some boards)
__________________
"My mom said the only reason men are alive is for lawn care and vehicle maintenance." - Tim Allen |
|
|
|
|
|
#3 |
|
DriverHeaven Senior Member
|
Re: Are these dangerous temperatures?
Well, I was reseating my cpu cooler because of a bad placement before (which by the way is ridiculous (socket775 push pins
)) and i removed 2x80mm fans off my side panel, but they were both aiming directly at my graphics card and i'm confident they couldn't push air all the way to the motherboard . I ended up putting one back last night, and it now reports the system temperature to be 41*C... so i think problem solved until summer might be an excuse to get a new case
|
|
|
|
|
|
#4 |
|
DriverHeaven Extreme Member
|
Re: Are these dangerous temperatures?
You never need an excuse to get a new case
![]() Glad it is sorted for now mate
__________________
"My mom said the only reason men are alive is for lawn care and vehicle maintenance." - Tim Allen |
|
|
|
|
|
#5 | |
|
DH's Dormant Dragon
|
Re: Are these dangerous temperatures?
some of the nforce 2/4 chipsets registered in the 60-80*C range and worked relatively well...... course they have such a high failure rate.... erg
__________________
Quote:
|
|
|
|
|
|
|
#6 |
|
DriverHeaven Senior Member
|
Re: Are these dangerous temperatures?
same thing with a rig i sold about a year ago, yip you guessed it twas an nforce board. long story short it was reading 55'C from start up it went up to 70' C after less than 2min running.
The actual temp reading was about 45'C though from a thermometer guage. The temp sensors on the cpu was messed goooooooo nforce.
__________________
"I just want to make sure that this sensation really is hunger before i go and eat... " Emma Obita You Tube |
|
|
|
|
|
#7 |
|
cheap philanthropist
|
Re: Are these dangerous temperatures?
If the temperature warning threshold is at 45C then it's just a poorly designed piece of software. The temperature is really fine and there's no need for concern. Perhaps there's a newer version of the AI Suite that is better, but these software utilities that come bundled with motherboards are often not of any higher quality.
|
|
|
|
|
|
#8 |
|
DriverHeaven Senior Member
|
Re: Are these dangerous temperatures?
that old rubbish rig, i got the motherboard replaced @ the manufacturers it took a while (1month) and my customer was not happy
![]() . I'm not too devastated that the Nvidia-AMD collabo fell through. Some good can come out of Economic problems: weak and sub-par electronics fall to the weigh-side[i don't think that's the spelling but who cares!]techno-evolution and adaptation take that Charles Darwin .
__________________
"I just want to make sure that this sensation really is hunger before i go and eat... " Emma Obita You Tube |
|
|
|
|
|
#9 |
|
DriverHeaven Senior Member
|
Re: Are these dangerous temperatures?
That said, I got a CM HAF932 today YAY!!! motherboard is now at 34*C
PS. this thing is gigantic |
|
|
|
|
|
#10 |
|
DriverHeaven Extreme Member
|
Re: Are these dangerous temperatures?
Nice choice on the case man and cool on the temps (pun intended lol)
__________________
"My mom said the only reason men are alive is for lawn care and vehicle maintenance." - Tim Allen |
|
|
|
![]() |
| Bookmarks |
| Thread Tools | |
|
|