How to hear ASIO only Sounds ????

Sonic-Sam · Mar 1, 2004, 10:27 PM

Hi :

First , your KX Project is more than good , infact it's amazing.....

but here i have found this issue and it bothers me.
I'm using Logic 5.0.1, and it works very fine with the kx ASIO drivers , i did setup the inputs and outputs and here what i get :

The dry SPDIF signal still sound through the outputs, though it routes and recorded through Logic. How can I hear the wet sound only ????
I tried and reconnected the wires though the DSP editor but the problem didnt solved...

second thing is that, the Logic's outputs all routed to the basic (wave/Mp3) output , how can I route the outputs to the another board's outputs like the rear ones ????

Thanks for any replies.

SonicSam
P4 / 1GigRAM / 80GigHD / Audigy2 platinum

Daniel Drummond · Mar 2, 2004, 12:36 AM

try disconnecting spdif connecton from prolog to xrouting (without lowering it's volume level).

**dj_stick** · Mar 2, 2004, 02:12 AM

in the kx mixer in and out page, mute everything to do with s/pdif