Phaser updated.

Russ

I updated the phaser plugin to version 2.

In this version, there is an option for selecting the number of stages to use (2, 4, or 6).
I added a Cross-Feed slider (for mixing parts of the left and right channels together).
I modified the ranges of most of the sliders for greater configurability.

These changes should allow for many more possibilities in the type of sound you can get using this plugin.

I still need to add some presets, and polish up the GUI a bit, but other then that I think it is good to go.

You can download the new version here.

(available for 3537/3538h/3538i)

-Russ

thomasabarnes

Thanks for the info, Russ. And it's great that you have the 3538c, g, and h downloads available on your site, too!

Russ

I made a change to the sweep rate, as I think the range was too much. Anything above 10Hz seemed to only be useful for a small number of configurations, and left a lot of room where modifying the rate seemed to have no effect with most configurations. For this reason I set the max sweep rate to 10Hz. The download link is updated with this change.

Russ

I made another couple of small changes. I modified the sweep range to use increments of 0.125 (1/8 octave), for more control over that parameter, and I modified the code slightly for better response at the lower sweep range settings, and for better response in general to all parameter changes.

I also updated the 3537 version (available near the bottom of the page with the rest of the 3537 stuff). I was unable to test the 3537 version, so let me know if there are any problems with it.

-Russ

Russ

Now that I have installed the previous 3538 SDK again, I added the 3538h version to the download page as well.

Russ

There is a small bug with the crossfeed code that effects the right channel. I will correct it, and update the plugins when I have the time to do so.

-Russ

Russ

I corrected the crossfeed code and updated all (V2) versions of the plugin. The link is in the first post of this thread.

-Russ