Overclocking prob, Need Help, Please!

ThE_KrEaToR · Jun 13, 2005, 02:40 PM

Hi i know i've probably posted this in the wrong place but i need some help. I was overclocking my graphics card earlier using radlinker, when my brother can into my room and started argueing with me. I turned my back and he changed the two Mhz sliders on radlinker down to about 30 Mhz each!!

My comps screen went all fuzzy and then the comp froze. Everytime i boot the comp now, windows loads up but the screen is all fuzzy and i cant see anything to change the settings back, then about 1/2mins after booting up it just goes the a black screen

. Please help is there some type of fail safe opition i can enable at startup by pressin summit

. Please help

Thanks.

H3X4D3C1M4L · Jun 13, 2005, 03:29 PM

Try going into Safe Mode, by pressing F8 after your system beeps. If it still happens there, you borked it . But I dont think you would have borked it that easily.

In any case just blame your brother

ThE_KrEaToR · Jun 13, 2005, 04:14 PM

Thanks ALOT m8, i pressed f8 and seen a option sayin VGA safe mode i selected it and it didnt stop the prob but it made all the icon big enuff for me to just make out what was what, so i'm ok now, thanks again m8

H3X4D3C1M4L · Jun 13, 2005, 04:20 PM

No problem

perhaps from there you can uninstall things.