DriverHeaven.net - View Single Post

Maddogg6 · Feb 10, 2006, 12:11 PM

I only have Cubase SX3 - so the following my be different for different versions of Cubase.

So - you installed Soundfonts - and selected them properly in a midi track?

And you can see the patches listed when you open 'Devices/KX Synth XXXX' (the same screen you can load banks within cubase)

Then in KX mixer - 'Master Page' you made sure the KX SYNTH level was high enough.
The MASTER VOLUME level is also up too.

And your desired output is enabled and level is high enough.

If so - do you see any activity in the KX MIXER - ANAYLSER PAGE While midi is playing back?

Maddogg6's System Specs
Processor:	P IV (630) 3.0 Ghz
RAM:	2 x 512MB DDR2
Graphics:	FX6600
Mainboard:	Intel 915PCY
Operating System:	Windows XP

Feb 10, 2006, 12:11 PM	#2 (permalink)
Maddogg6 Tail Razer Join Date: Jun 2005 Location: Bernyurass, AZ - USA Posts: 3,628	I only have Cubase SX3 - so the following my be different for different versions of Cubase. So - you installed Soundfonts - and selected them properly in a midi track? And you can see the patches listed when you open 'Devices/KX Synth XXXX' (the same screen you can load banks within cubase) Then in KX mixer - 'Master Page' you made sure the KX SYNTH level was high enough. The MASTER VOLUME level is also up too. And your desired output is enabled and level is high enough. If so - do you see any activity in the KX MIXER - ANAYLSER PAGE While midi is playing back?